Siemens MPA 1 Series Instruction Manual page 22

s
Target object
T = 900 °C
O
Emissivity  < 1
Reflection  > 0
Temperature offset using linear interpolation
When necessary, ARDOMETER MPA allows you to program an offset
for the temperature reading reported. The offset correction can be con-
figured individually with a minimum of 2 and a maximum of 10 interpolat-
ing points (X/Y nodes). This information is stored in a user-defined tem-
perature-indexed lookup table and used for signal conditioning. For val-
ues lower than the 1st node and higher than the last node, the first and
last linear segments are extrapolated. Enter the nodes in ascending or-
der. Use the rear panel display to access this function via
LIN.1.
Furnace radiation T = 950 °C
Back
16
Operating Manual MPA
Source of extraneous
radiation. Example:
furnace 950 °C
C001 /