Table of Contents
Advertisement
Hypro centrifugal pumps are designed for creating and boosting pressure in fluid circuits. The pump operates by taking
in fluid from the inlet port after which it is slung by the impeller and expelled through the outlet port. Construction features
include housings, impellers and seals which come in a variety of materials in order to be resistant to a range of chemicals.
Standard models of centrifugal pumps rotate clockwise, when looking at the front of the pump.
Hypro centrifugal pumps are intended for creating or boosting dynamic pressure in approved fluids. Hypro centrifugal
pumps should never be used to pump liquids above 140°F (60°C), or below 34°F (1°C). Any uses outside of those
specified in this manual are considered misuses and are prohibited. Contact Hypro technical service about any questions
regarding specific acceptable uses.
This manual provides instructions and requirements that must be met when installing, using and maintaining the
product(s) identified on the cover.
If the product is sold, the seller must pass this manual on to the new owner.
The following special attention notices are used to notify and advise the user of this product of procedures that may be
dangerous to the user or result in damage to the product.
Attention is used to notify of installation, operation, or maintenance information that is important but not safety related.
This symbol is used to denote the presence of an electrical hazard that will result in personal injury, death or property
damage.
This symbol is used to denote the presence of a hazard that will result in personal injury, death or property damage.
California Proposition 65 Warning -- This product and related accessories contain chemicals known to the
State of California to cause cancer, birth defects or other reproductive harm.
Hypro centrifugal pumps are designed to operate effectively within the specified speed, pressure and environmental
ranges. Going outside of these ranges will void the warranty and could cause damage to property or serious injury or
death.
•
DO NOT run the pump faster than the maximum specified speed.
•
DO NOT run the pump higher than the maximum specified pressure.
•
DO NOT run pumps when the liquid has exceeded the maximum or minimum temperature limit (See Intended Uses).
•
DO NOT pump non-approved liquids.
•
DO NOT pump water or other liquids for human consumption.
•
DO NOT operate any pump under the influence of drugs or alcohol.
•
DO NOT run the pump dry.
Introduction
Description
Intended Uses
Purpose of Manual
ATTENTION
Misuses
- 4 -
Advertisement
Table of Contents
