Pentair Hypro 1502 Repair Manual
Pentair Hypro 1502 Repair Manual

Pentair Hypro 1502 Repair Manual

Roller pumps
Hide thumbs Also See for Hypro 1502:

Advertisement

HYPRO
®
Series 1502
6-Roller Pump
Series 4001 & 4101
4-Roller Pump
Series 7560
8-Roller Pump
Pentair
Pentair
375 5th Ave., New Brighton, MN 55112 USA
375 5th Ave., New Brighton, MN 55112
Phone: (651)766-6300 -OR- 800-424-9776 Fax: 800-323-6496
Phone: (651)766-6300 -OR- 800-424-9776 Fax: 800-323-6496
www.hypropumps.com
www.hypropumps.com
Authorized Representative:
EU Authorized Representative:
Repair Manual
Keep for Future Reference
QNET BV Hommerterweg 286
EC REP
6436 AM Amstenrade, The Netherlands
QNET BV Hommerterweg 286
EC
REP
KvK Zuid-Limburg 14091511
6436 AM Amstenrade, The Netherlands
KvK Zuid-Limburg 14091511
Hypro Series 1502, 1700, 4001, 4101,
6500, 7560 and 7700 Roller Pumps
Form L-1572R
Series 1700
5-Roller Pump
Series 6500
6-Roller Pump
Series 7700
7-Roller Pump
Rev. A

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Hypro 1502 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Pentair Hypro 1502

  • Page 1 4-Roller Pump 6-Roller Pump Series 7560 Series 7700 8-Roller Pump 7-Roller Pump Pentair Pentair 375 5th Ave., New Brighton, MN 55112 USA 375 5th Ave., New Brighton, MN 55112 Phone: (651)766-6300 -OR- 800-424-9776 Fax: 800-323-6496 Phone: (651)766-6300 -OR- 800-424-9776 Fax: 800-323-6496 www.hypropumps.com...
  • Page 2: Repair Instructions

    REPAIR Repair Instructions To Take the Pump Apart Remove the adapter from the pump shaft, if equipped. File off any burrs on the pump shaft. Using a screwdriver, pry off the bearing cover on the endplate and pump body. Remove the endplate bolts. Support the pump at its ports in a support fixture with the endplate down.
  • Page 3 Repair Instructions - cont’d. Re-Assembly Replace Seals and Bearings Carefully place the seal in the pump body with crimped side down. Press the seal to the bottom of the cavity. Then put the bearing in position in the pump body and press into place (Figure 11). Repeat the above procedure with the endplate.
  • Page 4 Reversing Rotation 1. Determine the rotor type of your pump by referring to exploded drawing on the parts list. The three types of Standard NON-SCOOP Rotor rotors are NON-SCOOP, SCOOPED, and SLANTED SLOT. 2. Follow the steps listed in Repair Instructions for disassembly of the pump.

Table of Contents