Table of Contents
Advertisement
For cor rect op er at ing pro ce dures see the "Op er a -
tion" chap ter 10.
NOTE
Pay particular attention to the Emergency Stop
switch
to see that it turns the MHP15/44HD V2
engine off when the red button is struck.
With the booms raised operate the Emergency
Lower Switch
in conjunction with the Enable
Switch
. The booms should begin to lower.
For details on correct emergency lowering
operating procedures see "Emergency Operation"
chapter 11.
Platform Control Switches
Machines with Electric Controls
UPPER
BOOM
LOWER
BOOM
13371-3 REV
SLEW
FUEL
ELECTRIC
START
Figure 9.18 - Platform Control Switches
On the ground con trol box set the Ground/Plat -
form Se lec tor to plat form.
Check that each of the platform moving switches
(
through to
) cause the platform to move the
way it should.
Check both po si tions of each switch.
For cor rect op er at ing pro ce dures see the "Op er a -
tion" chap ter 10.
NOTE
Pay particular attention to the Emergency Stop
switch
to see that it turns the MHP15/44HD V2
engine off when struck.
Pay particular attention to the platform foot switch
to see that it deactivates the platform moving
switches when the foot switch is not stepped on.
Emer gency lower from the up per con trol box is
achieved by op er at ing the En able Switch
press ing the Foot Switch whilst op er at ing the
Emer gency Lower Switch
MHP15/44HD V2 – 13620-1
LIFT
ENABLE
lb
kg
JIB
BOOM
ROTATE
PLATFORM
SPEED
13371-2
CHOKE
EMERGENCY LOWER
ENABLE
or de -
9. Pre-operational Inspection
For de tails on cor rect emer gency low er ing op er at -
ing pro ce dures see "Emer gency Op er a tion" chap -
ter 11.
At the completion of the above section the unit
can be returned to the stowed position.
Rev B
page 9 - 7
Advertisement
Table of Contents
