Table of Contents
Advertisement
Troubleshooting
All of the ac tions de scribed in this chap ter may be
per formed by an MHP15/44HD V2 op er a tor, a
trained and qual i fied ser vice tech ni cian is not re -
quired.
The first col umn, of the fol low ing chart, lists some
com mon prob lems en coun tered by MHP15/44HD
V2 op er a tors.
The sec ond col umn lists some of the causes for
Operator Troubleshooting Chart
Problem
Engine will not crank.
Engine cranks but will
not start.
Engine runs but no
outrigger function.
Engine runs but no
boom function.
Bleed down at platform
inoperative.
Platform tilting
each prob lem. The third col umn lists rem e dies.
MHP15/44HD V2 – 13620-1
Cause
1. Flat battery.
2. Main circuit breaker, in
ground control box, has
tripped..
3. Loose battery terminals . Tighten battery leads at battery.
1. Out of fuel.
2. Fuel tap off.
1. Leg / boom switch in
lower control box
incorrectly set
1. Speed control set too
SLOW.
2. Stabilisers not set
correctly.
3. Lack of hydraulic oil.
1. Flat battery.
Upper boom going too high
Rev B
15. Operator's Troubleshooting
CAUTION
Any problem that cannot be fixed by actions
listed below should be referred to a trained
and qualified MHP15/44HD V2 service
technician.
Remedy
Replace / charge battery.
Reset circuit breaker , then try to start the
engine. If it will not start, refer the problem to
a qualified service technician.
Fill the engine with the correct type / grade of
fuel.
Locate fuel tap on engine and turn to ON.
Switch to Stabilisers to operate stabilisers.
Turn Speed Control C.W. until function
starts.
All stabilisers must be set on firm ground
before boom functions will operate.
A. Check hydraulic system for leaks.
B. Top up the oil tank with the correct type
/ grade of hydraulic oil.
A. Charge / replace the battery.
Have over-centre valve setting checked
page 15 - 1
Advertisement
Table of Contents
