Table of Contents
Advertisement
9. Pre-operational Inspection
Figure 9.14.2 - Lanyard Anchor Points -
Fibreglass Platform
Vi su ally check the lan yard an chor points to see that
they are not de formed or cut off.
Platform Gravity Gates
Figure 9.15 - Platform Gravity Gates
Check to see that the three (3) grav ity gates are
pres ent and func tion cor rectly.
Platform Guardrails
Figure 9.16 - Platform Guardrails
Vi sually in spect the plat form guard rails to see that
none of the tub ing has been cut out, re moved, or
de formed in any way. Vi sually check the guard rail
welds to see that none is cracked nor ground down.
page 9 - 6
Flashing Light (option)
Visually check the optional flashing light, to see
that the light flashes at approximately one (1) flash
per second when the motor key switch is turned on.
Before proceeding with the next section of the
Pre-operational Inspection you will need to start
the engine and set the stabilisers. Refer to the
'Operation' chapter if you need assistance with
this.
NOTE: - Control Options
If your machine has hydraulic controls go to page
8
Ground Control Switches
Machines with Electric Controls
SPEED
LOWER
BOOM
ENABLE
PLATFORM
ON
OFF
ON
BASE
ENABLED
ENABLED
DISABLED
DISABLED
HEIGHT
HEIGHT
LOCKOUT
LOCKOUT
Figure 9.17 - Ground Control Switches
With the Ground/Platform Selector
ground/base:
Check that each of the platform moving switches
(
through to
) cause the MHP15/44HD V2 to
move the way it should.
Check both po si tions of each switch.
Rev B
UPPER
JIB
BOOM
BOOM
lb
kg
LIFT
ENABLE
SLEW
FUEL
BOOMS
ELECTRIC
STABILISER
START
CHOKE
EMERGENCY
LOWER
set to
MHP15/44HD V2 – 13620-1
Advertisement
Table of Contents
