Jung eNet FMHS2 Operating Instructions Manual

Jung eNet FMHS2 Operating Instructions Manual

Radio hand-held transmitter

Advertisement

Quick Links

eNet radio hand-held transmitter
eNet radio hand-held transmitter 2-gang
Art. no.: FMHS2
eNet radio hand-held transmitter 4-gang
Art. no.: FMHS4
Operating instructions
1

Safety instructions

Electrical devices may only be mounted and connected by electrically skilled persons.
Serious injuries, fire or property damage possible. Please read and follow manual fully.
The radio communication takes place via a non-exclusively available transmission path, and is
therefore not suitable for safety-related applications, such as emergency stop and emergency
call.
These instructions are an integral part of the product, and must remain with the end customer.
2

Battery safety instructions

This device or its accessories are supplied with batteries in the form of button cells.
DANGER! Batteries can be swallowed. This can lead directly to death by suffocation. Danger-
ous substances may cause severe internal burns leading to death within 2 hours.
Keep new and used batteries away from children.
Do not use devices if the battery compartment does not close securely and keep away from
children.
If you suspect that a battery has been swallowed or is in any orifice of the body, seek immediate
medical attention.
WARNING! Improper handling of batteries can result in explosion, fire or chemical burn due to
leakage.
Do not heat or throw batteries into fire.
Do not reverse polarity, short-circuit or recharge batteries.
Do not deform or disassemble batteries.
Replace batteries only with an identical or equivalent type.
Remove empty batteries immediately and dispose of in an environmentally friendly manner.
3

Device components

(1)
Status LED
(2)
Release the
82582443
J0082582443
Figure 1: Radio hand transmitter 2-gang and 4-gang
1 / 7
18.12.2019

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the eNet FMHS2 and is the answer not in the manual?

Questions and answers

Summary of Contents for Jung eNet FMHS2

  • Page 1 eNet radio hand-held transmitter eNet radio hand-held transmitter 2-gang Art. no.: FMHS2 eNet radio hand-held transmitter 4-gang Art. no.: FMHS4 Operating instructions Safety instructions Electrical devices may only be mounted and connected by electrically skilled persons. Serious injuries, fire or property damage possible. Please read and follow manual fully. The radio communication takes place via a non-exclusively available transmission path, and is therefore not suitable for safety-related applications, such as emergency stop and emergency call.
  • Page 2 eNet radio hand-held transmitter Function Product characteristics – Two adjacent buttons each belong to one channel – Status indication with LED – Switch-on brightness of dimmer actuators can be saved. – Battery-powered device – Scenes, radio hand transmitter, 2x: All Off, three individual scenes. –...
  • Page 3 eNet radio hand-held transmitter Operating push-button actuator ■ Press the button. The load is switched on for the duration of the button-press. The maximum actuation length is 60 seconds. Recalling scenes ■ Press the scene button briefly. Actuators switching to the saved scene. Changing scene ■...
  • Page 4 eNet radio hand-held transmitter Hand-held transmitter is ready for operation. Configuring the buttons The Prog (Figure 2) button can be pressed with a thin wire or paper clip through the hole in the battery cover. Figure 2: Button Prog In the as-delivered state, all the buttons are configured as channel buttons. ■...
  • Page 5 eNet radio hand-held transmitter If the status LED of the actuator flashes 3 times at 1-second intervals for approx. 5 seconds, then the programming operation was not successful. All the memory locations in the actuator or radio transmitter are occupied. Press the Prog button once again for longer than 4 seconds to terminate the programming mode earlier.
  • Page 6 eNet radio hand-held transmitter Ambient temperature -5 ... +45 °C Degree of protection IP20 Dimensions L×W×H 55×40.5×15 mm Radio frequency 868.0 ... 868.6 MHz Transmission capacity max. 20 mW Transmitting range in free field typ. 100 m Receiver category Parameter list The device parameters can be changed with the eNet server: Device and channels Parameter name...
  • Page 7 Reduce the number of actuators connected to the transmitter. 11 Conformity Albrecht Jung GmbH & Co. KG hereby declares that the radio system type art. no. FMHS2/ FMHS4 corresponds to the directive 2014/53/EU. You can find the full article number on the device. The complete text of the EU Declaration of Conformity is available under the Internet address: www.jung.de/ce...

This manual is also suitable for:

Enet fmhs4

Table of Contents