KTM 250 EXC Six Days TPI 2019 Owner's Manual page 74

12 SERVICE WORK ON THE CHASSIS
72
–
Position the upper triple clamp with the handlebar.
–
Position the clutch line and wiring harness.
–
Mount screw
E00921-11
–
Position the voltage regulator, and mount and tighten
5
screws .
Guideline
Remaining screws,
chassis
–
Secure wiring harnesses with cable holders.
E00920-11
–
Position the fork legs.
Bleeder screws
Info
The rebound damping is located in right fork leg REB
(red adjusting screw). The compression damping is
located in left fork leg COMP (white adjusting screw).
Grooves are milled into the side of the upper end of the
fork legs. The second milled groove (from the top) must
H01672-10
be flush with the top edge of the upper triple clamp.
–
Tighten screws
Guideline
Screw, bottom triple
clamp
E00914-13
–
Tighten screw
Guideline
Screw, top steering
head
E00926-10
4
but do not tighten yet.
M6
6
are positioned toward the front.
7
.
M8
4
.
M20x1.5
10 Nm (7.4 lbf ft)
15 Nm (11.1 lbf ft)
12 Nm (8.9 lbf ft)