Horizontal Mounting (Travel Axis) Without Alignment Laser - Leuze electronic DDLS 538 Series Original Operating Instructions

Mounting
4.3.1

Horizontal mounting (travel axis) without alignment laser

Ä Depending on mechanical conditions, mount the stationary or mobile device with four M5 screws via
the fastening holes in the mounting plate.
Ä Move the mobile device as close as possible to the stationary device.
Ä Determine the vertical mounting position of both devices.
ð Place an alignment straightedge or level on top of the planar support surfaces in the connection
area of both devices.
ð Move the devices until they are at the same height.
Ä Determine the horizontal mounting position of both devices.
ð Place an alignment straightedge or level on the lateral support edge of one of the devices.
ð Move the devices towards one another horizontally so that there is an offset of 30 mm between
them (see figure). The transmitter of one device is positioned opposite the receiver of the other de-
vice.
Fig. 4.8: Mounting with offset housings
ð Mounting of the device is concluded.
Further procedure:
• Connect the devices electrically (see chapter 5 "Electrical connection").
• Perform the fine adjustment for the travel axis (see chapter 6.2 "Fine adjustment").
Leuze electronic GmbH + Co. KG
30 mm
DDLS 538 ... 32