Mounting Without Alignment Laser - Leuze electronic DDLS 538 Series Original Operating Instructions

Optical data transmission for ethercat

Hide thumbs

Table Of Contents

Table of Contents

Mounting

NOTICE

You will achieve greater flexibility during basic installation and fine adjustment if you mount the

devices on C profile rails.

Ä Detach the contour of the optical window from the drilling template along the perforation.

Ä Affix the removed drilling template to the optical window of the mobile device using the supplied self-ad-

hesive labels.

Ä Switch on the alignment laser of the stationary device. Activate the LAS (Alignment laser) operating

mode to switch on the alignment laser (see chapter 6.1 "Setting the operating mode").

Ä Move the mobile device on the lifting axis in manual operation to maximum distance.

Ä Align the stationary device using the alignment screws (see chapter 3.1.1 "Device construction",

point 11 and point 12) and, if necessary, using the C-profile rails.

ð The target spot of the alignment laser must be in the center of the drilling template on the mobile

device.

Ä Move the mobile device on the lifting axis in manual operation to minimum distance.

ð The target spot of the alignment laser must not extend beyond the outer ring of the drilling template

on the mobile device.

ð If necessary, realign the stationary device.

Ä Switch off the alignment laser of the stationary device. Activate the AUT (Automatic) operating mode to

switch off the alignment laser (see chapter 6.1 "Setting the operating mode").

Ä Affix the detached drilling template to the optical window of the stationary device using the supplied

self-adhesive labels.

Ä Switch on the alignment laser of the mobile device. Activate the LAS (Alignment laser) operating mode

to switch on the alignment laser (see chapter 6.1 "Setting the operating mode").

Ä Move the mobile device on the lifting axis in manual operation to maximum distance.

Ä Align the mobile device using the alignment screws (see chapter 3.1.1 "Device construction", point 11

and point 12) and, if necessary, using the C-profile rails.

ð The target spot of the alignment laser must be in the center of the drilling template on the stationary

device.

Ä Move the mobile device on the lifting axis in manual operation to minimum distance.

ð The target spot of the alignment laser must not extend beyond the outer ring of the drilling template

on the stationary device.

ð If necessary, realign the mobile device.

Ä Switch off the alignment laser of the mobile device. Activate the AUT (Automatic) operating mode to

switch off the alignment laser (see chapter 6.1 "Setting the operating mode").

Ä Remove the drilling template from the stationary device.

ð This concludes the mounting of the devices in the lifting axis.

Further procedure:

• Perform the fine adjustment for the lifting axis (see chapter 6.2 "Fine adjustment").

4.3