Ethercat Factory Setting - Leuze electronic DDLS 538 Series Original Operating Instructions

EtherCAT
Slave-side installation
For devices installed on the slave side, the MAS EtherCAT configuration must be deactivated. The MAS
LED of the device is off.
E therC A T
1
1 Master
2 Bus terminals
3 DDLS 538 ... master side
4 DDLS 538 ... slave side
5 Operating mode/MAS configuration = off
Fig. 7.2: MAS EtherCAT configuration deactivated
7.3

EtherCAT factory setting

Factory setting of the MAS EtherCAT configuration
The DDLS 538 ... are delivered ex works with the following MAS EtherCAT configuration:
• Device with "Frequency F4": MAS EtherCAT configuration activated
• Device with "Frequency F3": MAS EtherCAT configuration deactivated
Leuze electronic GmbH + Co. KG
2
3
D D LS 538
„M A S " = on
4
D D LS 538
I/O 's
„M A S " = off
DDLS 538 ...
5
52