Hydraulic tunnel thruster with electronic controller (16 pages)
Summary of Contents for MAX power CT HYD 125 Series
Page 1
Manual Max Power Series 125HYD Last Update: July 2022 Hydraulic Tunnel Thruster Series CT HYD 125 INSTALLATION OPERATION MAINTENANCE Serial N° : ---------------------------------------------------- Date of Installation : ---------------------------------------- THIS MANUAL MUST BE KEPT ON BOARD AT ALL TIMES Via Philips 5, 20900 Monza (MI), Italy Tel.
Manual Max Power Series 125HYD Last Update: June 2022 To ensure a proper installation, correct usage and long-lasting enjoyment of this equipment, please take time to read this manual thoroughly. Table of Contents Number Description Page General Installation Guidelines Tunnel Propeller Drive Leg &...
Manual Max Power Series 125HYD Last Update: June 2022 GENERAL INSTALLATION GUIDLINES Decide on the best location for the MAX POWER. (See drawing: “Positioning & Measurements” at back of manual) The tunnel must be as low as possible and as far forward as possible.
Manual Max Power Series 125HYD Last Update: June 2022 CAUTION: Do not apply fiberglass to the area of the motor support. It is recommended to lightly sand down the area where the motor support is fitted. On the outside, when the ISOPHTALIQUE RESIN has set, finish with an application of resin and material, followed with an additional coat on the hull, in the tunnel area.
Manual Max Power Series 125HYD Last Update: June 2022 THE HYDRAULIC MOTOR AND ITS ADAPTER Do not separate the motor from its adapter. Insert the lower metal coupling on the greased leg shaft. Fit the flexible coupling, then the motor and its adapter, tighten the screws ( 10mm) to a torque of 40 Nm.
Use synthetic, mineral or vegetable hydraulic oil, to ISO standard 32 to 48. 8) HYDRAULIC SPECIFICATIONS MAX POWER Series 125 HYD: Flow = 30/35 liters/Min Pressure = 130 / 140 bars Detailed instructions and diagrams are delivered with each pack, specific to the installation...
Manual Max Power Series 125HYD Last Update: June 2022 MAINTENANCE In order to ensure peak performance from your thruster, the tunnel, the leg and the propellers must be kept clean. IMPORTANT: In order to prevent chalky deposits, which cause damage to the oil seals, we recommend cleaning the shaft and the oil seals first, then applying a layer of silicon oil before assembling the propellers.
The purpose of this document is to set out the terms of warranty cover offered in relation to products purchased by the End User from Max Power or its approved network of resellers. This document will adhere to the following format: -...
Page 17
IF POSSIBLE: PLEASE TAKE PHOTOGRAPHS OF THE THRUSTER TO SHOW PROBLEM The warranty as outlined above is only applicable to Max Power manufactured thrusters and optional equipment as used in marine pleasure industry. The supplier holds the exclusive right to test the product and determine whether it is defective.
Manual Max Power Series 125HYD Last Update: December 2016 DISTRIBUTER CONTACT LIST: SOUTHERN EUROPE: CYPRUS CYPRUS OCEAN MARINE EQUIPMENT LTD TUTI MARE TRADING Limassol Limassol Tel: + 357 53 69 731 Tel: + 357 25 431 313 Fax: + 357 53 52 976...
Page 19
Manual Max Power Series 125HYD Last Update: December 2016 U.K. PLASTIMO UK AR PEACHMENT Eastleigh, Hampshire Norfolk Tel: + 44 870 751 4666 Tel: + 44 1603 714 077 Fax: + 44 870 751 1950 Fax: + 44 1603 714 211 Email: sales@plastimo.co.uk...
Page 20
WARRANTY FORM VERY IMPORTANT Please complete this form and fax a copy to Max Power with a copy of the installation invoice or the invoice of the yacht/boat in order for the warranty to come into effect. To Be Completed by Owner: Name of Owner:…………………………….