8
General Setting
Auto power off after 2h
Disable Auto power off
4.
Press
DTMF Transmitting Time
1.
Press and hold
key for over 2s to enter general setting.
2.
Press
/
key to choose No.21
menu, LCD displays "SPD--50".
3.
Turn selector knob to select the desired
setting.
30/50/100/200/300/500, which indicates the time for sending each
DTMF signal & the interval between each DTMF being sent.
4.
Press
24
Squelch level Setup
Setting the radio to a tight squelch level, you can avoid unwanted
signals or noise, but you may not receive a weak signal. Therefore, it will
be better for you to select the normal squelch level
1.
Press and hold
key for over 2s to enter general setting menu.
2.
Press
/
key to choose No.22
menu, LCD displays "SQL--04".
3.
Turn selector knob to select the desired
squelch level.
OF-20 total 21, OF is min setting value(ON)
4.
Press
Press
, then turn selector knob also can select the desired
squelch level.
If the transceiver has set at higher squelch level, it may fail to hear
the calling. If set at lower squelch level, the radio will be interfered.
Scan Dwell Time Setup
There are 3 kinds of Scan Dwell Time for option.
1.
Press and hold
key for over 2s to enter general setting menu.
2.
Press
/
key to choose No.23 menu, LCD displays "SCAN-
-TO".
3.
Turn selector knob to select the desired Scan Dwell Time.
It pauses 15s once scanning a
matching signal, then resume scan.
It pauses once scanning a matching
signal, signal disappeared then resume
scan.
It stops once scanning a matching
signal.
4.
Press
and exit.Default:TO.
LCD Backlight
1.
Press and hold
key for over 2s to
enter general setting menu.
2.
Press
/
key to choose No.24
menu, LCD displays "LAMP--25".