Table of Contents
Advertisement
PANEL AND BACK BOX INSTALLATION
T
he following guide lines should be followed with respect to the installation and care of the VR120
panel and accompanying back box. The back box should be adequately secured to the wall to prevent
risk of injury.
• To prevent water ingress to the VR120 panel ensure that a good seal between the back box and the
face plate itself is made. The neoprene seal on the face plate will offer this as long as the back box
front is flush with the wall surface. Always ensure the panel is tightened sufficiently to compress the
neoprene seal.
• In the event of gaps due to uneven walls we suggest using a silicon sealant be used. In the event of
water ingress to the back box we would also suggest drilling 3x4mm holes at the bottom of the back
box to allow any collection of water to escape.
• Always ensure all cable entry points are sufficiently sealed to prevent water ingress (refer to Fig.1,
Fig 2 and Fig.3). All cables should loop down and then back up to the termination connections to
avoid any water travelling along the cable and onto the pcb.
FRONT VIEW
FRONT VIEW
Page 38
120 VANDAL RESISTANT AUDIO AND VIDEO TECHNICAL MANUAL VER 1.0
FLUSH BACK BOX (VRFB120x280)
REAR VIEW
BEZEL BACK BOX (VRBB120x280)
REAR VIEW
Fig.1
Fig.2
Advertisement
Table of Contents
