Pre-Tracking Belt - Grizzly T32459 Owner's Manual

5. While holding belt tension handle to keep
gas strut compressed, remove old belt from
wheels and replace with new one, being sure
arrows on belt match belt rotation arrow on
machine (see Figure 32).
Figure 32. Location of belt rotation arrow.
6. Move platen assembly as far forward as you
can without stretching belt (see Figure 33),
then tighten platen lock handle.
Figure 33. Pulling platen assembly forward.
7.
Center belt on wheels and platen, then slowly
release belt tension handle to tension belt.
8.
Belt MUST be pre-tracked before connecting
machine to power. Proceed to Pre-Tracking
Belt.
-24-
You must perform the following procedure after
installing a new belt to ensure that the belt does
not come off the wheels or get jammed against
the belt frame.
To pre-track belt:
1.
2.
3.
Belt
Rotation
Arrow
Belt Tracking Knob
Platen
Assembly

Pre-Tracking Belt

DISCONNECT MACHINE FROM POWER!
Install desired belt as described in Installing/
Changing Belt on Page 23.
Loosen wing nut shown in Figure 34.
Figure 34. Belt tracking components.
Tip: Loosen tool rest lock handle to remove
tool rest assembly while tracking belt for
unobstructed view of platen and wheels.
Model T32459 (Mfd. Since 03/23)