Grizzly T32459 Owner's Manual page 20

12. Once belt tracks centered on wheels, slowly
turn variable-speed dial back and forth to test
variable-speed function.
Motor should run smoothly and without
unusual problems or noises, and belt MUST
rotate in same direction as belt rotation arrow
on machine (see Figure 21).
Figure 21. Location of belt rotation arrow.
— If motor runs smoothly and belt rotates in
correct direction, proceed to Step 13.
— If motor does not run smoothly, or belt does
not rotate in correct direction, turn machine
OFF and disconnect power. Contact
Technical Service before proceeding.
13. Press EMERGENCY STOP button to turn
machine OFF.
14. WITHOUT resetting EMERGENCY STOP
button, try to start machine with ON/OFF
switch and variable-speed dial. Machine
should not start.
— If machine does not start, safety feature
of EMERGENCY STOP button is working
correctly. Proceed to Step 15.
— If machine does start, immediately turn it
OFF and disconnect power. Safety feature
of EMERGENCY STOP button is NOT
working properly and must be replaced
before further using machine.
15. DISCONNECT MACHINE FROM POWER!
-18-
16. Adjust wing nut on belt tracking knob without
17. Loosen tool rest lock handle, install tool
Belt
Rotation
Arrow
Figure 22. Tool rest installed on machine.
18. Loosen cap screw shown in
workbench and location of tool rest angle cap
moving knob so it contacts frame to secure
tracking setting.
rest, adjust it so there is no more than
between rest and belt, then tighten handle to
secure (see Figure 22).
Note: If front wheel cover prevents you from
adjusting tool rest within
Step 18 first.
Tool Rest
Lock Handle
adjust tool rest so it is about parallel to work-
bench, then tighten cap screw to secure.
Congratulations! Test Run is complete.
Figure 23. Tool rest adjusted parallel to
screw.
Model T32459 (Mfd. Since 03/23)
⁄
"
1
16
⁄ " of belt, perform
1
16
Tool Rest
Figure 23,