Table of Contents
Advertisement
Please note: If the external power supply specification is
higher than the DC12v battery that comes with the unit, it
may be started by hand, electric start or remote control.
If the power specification of the external source is less than
the original generator battery, the current it provides will not
be enough to start the generator. Therefore, it must only be
started by hand to prevent damage to the electrical system
or the DC12v power supply.
2. Remove the choke and manually pull to start
After removing the left-hand side cover of the unit, if the
engine is cold, the choke should be turned to the closed
state; if the engine is warm, the choke needs to be turned to
the open state. Normal hand-pull start may then be
performed via the starter handle. The generator can be
started. If it still can't start normally, try to move the choke to
the middle position and try to start by hand. The operating
position is shown in the figure below
31
Advertisement
Table of Contents
