Ac Indicating Light (Green); Eco Switch - Lifan KP4500iE Owner's Manual

Silent inverter generator

Table of Contents

3. Check whether there is a foreign body blocking the air inlet

or if there is any abnormality with the relevant control parts

and eliminate if necessary.

4. After checking, press the voltage recovery button for 1-3

seconds and restart.

Notice: When using electrical equipment with a high start-up

current such as compressors or submersible pumps, the

overload indicating light may flash for few seconds however

this may not necessarily indicate the previously mentioned

faults. Overload, short circuit, overheating and low engine

speed can all prevent output. Eliminate the above reasons

until output is restored

4.3 AC Indicator Light (GREEN)

The AC indicating light will remain lit

throughout operation with stable output

① "ON"

While the ECO switch is on position of "ON",

the equipment will control the throttle speed

according to the connected load, which can

achieve better fuel consumption and low noise.

② "OFF"

While the ECO switch is in the "OFF" position, the engine will

run continuously at the rated speed (3600r/min) regardless of

whether the load is connected.

NOTICE: The switch must be set to "OFF" when connecting

any equipment requiring a high start-up current

Table of Contents