ICON WEIDER POWER TOWER User Manual page 9

5. Attach a Footrest Frame (4) to one of the Bases
(1) with the two indicated M8 x 68mm Carriage
Bolts (20) and two M8 Locknuts (22); do not
tighten the Locknuts yet.
Next, attach the Footrest Frame (4) to the
Upright (2) with two M8 x 75mm Bolts (17), two
M8 Curved Washers (23), and two M8 Locknuts
(22); do not tighten the Locknuts yet.
Attach the other Footrest Frame (4) to the
other Base (1) and the other Upright (2) in the
same way.
6. Orient one of the Pull-up Frames (3) as shown,
and insert it into one of the Uprights (2). Attach
the Pull-up Frame with two M8 x 68mm Bolts
(24), two M8 Curved Washers (23), and two
M8 Locknuts (22). Note: The Bolts must be
inserted into the lowest set of holes in the
Pull-up Frame and the Upright. Make sure
that the bolt heads are in the hexagonal
holes (C) in the Upright. Do not tighten the
Locknuts yet.
Attach the other Pull-up Frame (3) to the
other Upright (2) in the same way.
5
22
4
22
22
22
6
3
2
22
9
2
2
23
17
23
1
4
1
20
3
24
23
C
2
23