Energy Saver Function - Olivetti PGL2545 Operation Manual

Table of Contents

Advertisement

Preparation before Use

Energy Saver Function

Sleep
For Europe
When the set time (factory setting is 1 minute) elapses after the printer is last used, the printer automatically enters sleep
mode. The message display backlight and lights turn off to minimize power consumption. This status is referred to as Sleep.
To use the printer, press [OK]. The printer will be ready to use within 18 seconds.
For more information about configuring settings, refer to Sleep Timer (Sleep timer timeout time) on page 4-110.
Except for Europe
When the set time (factory setting is 1 minute) elapses after the printer is last used, the printer automatically enters sleep
mode. The message display backlight and lights turn off to minimize power consumption. This status is referred to as Sleep.
There are two sleep modes: Quick Recovery and Energy Saver. The default setting is Energy Saver mode.
Quick Recovery Mode
The recovery from the sleep mode is faster than when using Energy Saver mode.
The message display goes off when sleep mode is entered and the Ready indicator flashes.
The machine recovers quickly when [OK] is pressed. The machine also automatically recovers and prints when a job is
detected.
If print data is received during Sleep, the print job is performed while the message display remains unlit.
To use the printer, press [OK].
Note that ambient environmental conditions, such as ventilation, may cause the machine to respond more slowly.
For more information about configuring settings, refer to Sleep Timer (Sleep timer timeout time) on page 4-110.
Energy Saver Mode
This mode reduces power consumption even more than quick recovery mode, and allows Sleep mode to be set separately
for each function.
IMPORTANT Cautions when setting the Energy Saver mode
• An ID card is not recognized when in Energy Saver mode.
To use the printer, press [OK].
Recovery time from Sleep Mode is as follows.
• PG L2555 25 seconds or less
• PG L2550: 20 seconds or less
• PG L2545: 15 seconds or less
For more information on Energy Saver settings, refer to Sleep Level Set. (Sleep level setting) on page 4-108.
Power Off Timer (for Europe)
If the printer is not used while in sleep mode, the power automatically turns off. The Power Off Timer is used to set the time
until the power turns off. The factory setting for the time until the power turns off is 3 days.
IMPORTANT You can set the power off rule and power off timer. For details, refer to Power Off Rule (Power Off Rule
setting) (for Europe) on page 4-110 and Power Off Timer (Power off timer settings) (for Europe) on page 4-111.
2-36

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pgl2550Pgl2555

Table of Contents