DHCP:
01
Off
*
On
02
IPv4 Setting:
01
DHCP
Auto-IP
02
IP Address
03
Entering the IP address
If DHCP is set to Off, enter the IP Address manually.
IP Address:
0.
IPv4 Setting:
01
DHCP
Auto-IP
02
IP Address
03
Entering the Subnet Mask
When DHCP is set to Off, enter the Subnet Mask manually.
Subnet Mask:
0.
14
15
16
Exit
17
18
0.
0.
0
19
20
Exit
21
22
0.
0.
0
Press [OK]. The DHCP screen appears.
Press or to select Off or On.
Press [OK]. The DHCP setting is set and the IPv4 Setting menu
reappears.
Note DHCP becomes effective when On is selected. Press
[Menu] to end the mode selection menu.
When Off is set, continue on to enter the IP Address.
Press or to select IP Address.
Press [OK]. The IP Address screen appears.
Use the numeric keys or or to set the IP address.
You can set any value between 000 and 255.
Increase or reduce the figures by pressing or .
Use and to move the position being entered, which is shown
highlighted.
Press [OK]. The IP address is stored and the IPv4 Setting menu
reappears.
Press or to select Subnet Mask.
Press [OK]. The Subnet Mask screen appears.
2-5
Preparation before Use