Table of Contents
Advertisement
Energy Saver Function
Low Power Mode
When the set time (factory setting is 1 minute) elapses after the printer is
last used, the printer automatically enters low power mode. The
message display backlight and lights turn off and power consumption is
reduced. This status is referred to as Low Power Mode.
The amount of time of no activity that must pass before Low Power
Mode is activated may be lengthened. For more information refer to Low
Power Timer (Low Power Mode timer timeout time) section of the
Advanced Operation Guide.
If print data is received during Low Power Mode, the message display
lights up and printing starts.
To resume, press [GO]. The printer will be ready to operate within
8 seconds or less.
Note that ambient environmental conditions, such as ventilation, may
cause the machine to respond more slowly.
Sleep
For Europe
When the set time (factory setting is 15 minutes) elapses after the printer
is last used, the printer automatically enters sleep mode. The message
display backlight and lights turn off to minimize power consumption. This
status is referred to as Sleep.
To use the printer, press [GO]. The printer will be ready to operate within
16.5 seconds or less.
For more information about configuring settings, refer to Sleep Timer
(Sleep timer timeout setting) section of the Advanced Operation Guide.
Except for Europe
When the set time (factory setting is 1 minute) elapses after the printer is
last used, the printer automatically enters sleep mode. The message
display backlight and lights turn off to minimize power consumption. This
status is referred to as Sleep.
For more information about configuring settings, refer to Sleep Timer
(Sleep timer timeout setting) section of the Advanced Operation Guide.
There are two sleep modes: Quick Recovery and Energy Saver. The
default setting is Energy Saver mode.
Quick Recovery Mode
The recovery from the sleep mode is faster than when using Energy
Saver mode.
The message display goes off when sleep mode is entered and the
Ready indicator flashes.
The machine recovers quickly when [GO] is pressed. The machine also
automatically recovers and prints when a job is detected.
If print data is received during Sleep, the print job is performed while the
message display remains unlit.
To use the printer, press [GO].
4-28
Connecting and Printing
Advertisement
Table of Contents
