4.19 RESETTING THE TRANSCEIVER'S MICROPROCESSOR
Resetting the microprocessor restores the initial, factory-supplied conditions
in the transceiver. These are called the "default" conditions. To reset the
microprocessor, first turn the transceiver off. Then, while pressing and hold-
ing in the WX and SCAN keys, turn the transceiver on. The default condi-
tions are:
•
No channel numbers are in scan memory.
•
Channel 16 is the priority channel.
•
Channel 16 will be selected when the transceiver is turned on.
•
WX channel 01 will be recalled when the WX key is pressed.
•
Preset Channels are unassigned.
The above procedure also resets the microprocessor. Perform this pro-
cedure if an operational problem occurs which cannot be solved by nor-
mal operating procedures.
HX460S
NOTE
Page 21