Setup Mode - Standard Horizon HX460S Owner's Manual

4.17 SETUP MODE

The HX460S's Setup Mode allows a number of the HX460S operating pa-
rameters to be custom-configured for your operating requirements.
The Setup Mode is easy to activate and set, using the following procedure:
1. Turn the radio off.
2. Hold down the LAMP key, then turn on the transceiver while still holding
down the LAMP key.
3. "SET" will appear on the display, indicating that the Setup Mode has
been activated.
4. Press the LAMP key to select the Menu item to be adjusted.
5. Press the [ p ] or [ q ] key select the status or value of the Menu item.
6. After completing your adjustment, press the 16/9 key to save the new
setting and exit to normal operation.
4.17.1 beP ( K
EY
Function: Enable/Disable the Keypad beeper.
Available Values: ON/OFF
Default: ON
4.17.2 LP ( L
AMP
Function: Select the LCD/Keypad Lamp mode.
Available Values: KEY/TGL (Toggle)/5 (5 second)
Default: KEY
KEY: Illuminates the LCD/Keypad for 5 seconds when any key is
pressed.
TGL (Toggle): Pressing the LAMP key toggles the LCD/Keypad lamp On/
Off.
5 (5 second): Pressing the LAMP key illuminates the LCD/Keypad for 5 sec-
onds.
4.17.3 SCL ( S
Function: Enable/Disable the Scan lamp while scanning is paused.
Available Values: ON/OFF
Default: OFF
Page 18
)
B
EEP
)
M
ODE
)
L
CAN AMP
HX460S