Standard Horizon CP1000C Addendum page 5

Do not remove the C-Map MAX software update card until step 7 is completed.
The screen will be blank for about 40 seconds then a Internal WWB chart upload status screen will
be shown. On this screen you will notice the GPS chartplotter will erase the old WWB ground area,
write the new background to the GPS chartplotter, and verify the data has been loaded correctly.
5. After the software upgrade is finished the GPS chartplotter will show a message "Press
ENTER key to continue". Press [ENTER] and the GPS chartplotter will restart by
showing the startup screen.
6. Remove the C-Map MAX software update card and replace with C-Map data card.
7. Select the Chart page, press [MENU] and confirm MAX Functions is shown in the menu.
DURING NORMAL OPERATIONS THE C-CARD SHOULD NOT BE REMOVED DURING NORMAL OPERATIONS THE C-CARD SHOULD NOT BE REMOVED
DURING NORMAL OPERATIONS THE C-CARD SHOULD NOT BE REMOVED DURING NORMAL OPERATIONS THE C-CARD SHOULD NOT BE REMOVED DURING NORMAL OPERATIONS THE C-CARD SHOULD NOT BE REMOVED
ADDENDUM
CAUTION
NOTE
NOTE
SINCE THE UNIT MAY LOCK UP SINCE THE UNIT MAY LOCK UP
SINCE THE UNIT MAY LOCK UP SINCE THE UNIT MAY LOCK UP SINCE THE UNIT MAY LOCK UP
Page 7