Table of Contents
Advertisement
10
TECHNICAL SPECIFICATIONS
The product IBT4ZWAVE is produced by Nice S.p.a. (TV). Warnings: - All technical specifications stated in this section refer to an ambient
temperature of 20°C (± 5°C) - Nice S.p.a. reserves the right to apply modifications to the product at any time when deemed necessary, while
maintaining the same functionalities and intended use.
IBT4ZWAVE
Type
Technology adopted
Power supply
Absorbed current
Radio frequencies
Internal antenna max. transmit power
External antenna center frequency
External antenna max. peak gain
External antenna max. transmit power
External antenna cable length
Antenna connector screws rated torque
Casing protection rating
Operating temperature
Dimensions (mm)
Weight
11
Z-WAVE SPECIFICATION
The device is a Security Enabled Z-Wave Plus™ product and a Security Enabled Z-Wave gateway must be used in order to fully
utilize the product.
The device may be used with all devices certified with the Z-Wave Plus certificate and should be compatible with such devices produced by
other manufacturers.
The device works as a Z-Wave signal repeater (all non-battery operated devices within the network will act as repeaters to increase reliability of
the network).
Generic Device Type: GENERIC_TYPE_SWITCH_MULTILEVEL (0x11)
Specific Device Type: Not Used
Command Class
COMMAND_CLASS_ZWAVEPLUS_INFO [0x5E]
COMMAND_CLASS_MULTILEVEL_SWITCH [0x26]
COMMAND_CLASS_ASSOCIATION [0x85]
COMMAND_CLASS_MULTI_CHANNEL_ASSOCIATION [0x8E]
COMMAND_CLASS_ASSOCIATION_GRP_INFO [0x59]
COMMAND_CLASS_DEVICE_RESET_LOCALLY [0x5A]
COMMAND_CLASS_FIRMWARE_UPDATE_MD [0x7A]
COMMAND_CLASS_INDICATOR [0x87]
COMMAND_CLASS_MANUFACTURER_SPECIFIC [0x72]
COMMAND_CLASS_POWERLEVEL [0x73]
COMMAND_CLASS_SECURITY [0x98]
COMMAND_CLASS_SECURITY_2 [0x9F]
COMMAND_CLASS_SUPERVISION [0x6C]
COMMAND_CLASS_TRANSPORT_SERVICE [0x55]
COMMAND_CLASS_VERSION [0x86]
COMMAND_CLASS_NOTIFICATION [0x71]
COMMAND_CLASS_APPLICATION_STATUS [0x22]
COMMAND_CLASS_PROTECTION [0x75]
COMMAND_CLASS_CONFIGURATION [0x70]
COMMAND_CLASS_BASIC [0x20]
control using Z-Wave network of devices fitted with connector compatible with BUS T4
half duplex 19200 Bps serial connection on differential bus
24V DC supplied by the control unit to which the IBT4ZWAVE is connected
IP 40 (use indoors or in protected environments only)
Table 3 - Supported Command Classes
max 50 mA
868.0–868.6; 869.7–870.0 MHz
10 dBm
868 MHz
3 dBi
13 dBm
1 – 3 m
0.4 Nm
- 20 °C ÷ +50 °C
37 x 28 x h 21
10g
Version
V2
V4
V2
V3
V3
V1
V5
V3
V2
V1
V1
V1
V1
V2
V3
V8
V1
V2
V4
V2
Secure
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
Advertisement
Table of Contents
