ICON NordicTrack COMMERCIAL X32i User Manual page 29

SYMPTOM: The incline trainer will not connect to
the wireless network
a. Make sure that the wireless settings on the console
are correct (see page 23).
b. Make sure that the settings for your wireless net-
work are correct.
c. If you still have questions, go to support.iFIT.com.
SYMPTOM: The console does not stay in place
a. If the console will not stay in the desired posi-
tion because it is too loose, insert a hex key in
the two indicated locations (D) and turn the hex
key in quarter turn increments until the console is
tightened.
a
D
SYMPTOM: The displays of the console do not
function properly
a. If the console does not boot up properly, or
if the console freezes and does not respond,
reset the console to the factory default settings.
IMPORTANT: Doing this will erase all the
custom settings you have made to the console.
Resetting the console requires two people. First,
press the power switch into the off position. Next,
locate the small reset opening (E) on the side of
the console. Using a bent paper clip (F), press
and hold the reset button inside the opening, and
have a second person press the power switch into
the on (reset) position. Continue holding the reset
button (E) until the console turns on. When the
reset operation is complete, the console will turn
off and then turn back on. If it does not, use the
power switch to turn the incline trainer off and then
on again. Once the console turns on, check for
fi rmware updates (see step 5 on page 22). Note: It
may take a few minutes for the console to be ready
for use.
a
D
29
E
F