Emergency Box Raising; Fuses; Jump Starting Procedure - Toro Workman 3100 Operator's Manual

Center–to–center
Distance
Figure 48
,
2. To adjust loosen jam nuts at both ends of tie rod.
Figure 49
1. Tie rod
3. Rotate tie rod to move front of tire inward or outward.
4. Tighten tie rod jam nuts when adjustment is correct.

Emergency Box Raising

(without starting engine)
The box can be raised in an emergency by cranking starter
and holding lift lever. Run starter for 15 seconds then wait
60 seconds before engaging starter again.
If engine will not crank, the load and box (attachment)
must be removed to service engine or transaxle.

Fuses

There are 3 fuses in the machine's electrical system. They
are located under right side of dash panel.
1
43
FUSES
OPEN
LIGHTS & HORN
DASH
IGNITION
1
Figure 50
1. Fuse block

Jump Starting Procedure

Warning
Jump starting can be dangerous. To avoid personal
injury or damage to electrical components in
vehicle, observe the following warnings:
Never jump start with a voltage sources greater
than 15 volts D.C. This will damage the
electrical system.
Never attempt to jump start a discharged
battery that is frozen. It could rupture or
explode during jump starting.
Observe all battery warnings while jump
starting your vehicle.
Be sure your vehicle is not touching the jump
start vehicle.
Connecting cables to the wrong post could result
in personal injury and/or damage to the
electrical system.
1. Loosen knobs securing battery cover to battery base and
slide cover off.
––
15 A
25 A
10 A