Toro Workman 3100 Operator's Manual page 24

Oil Pressure Warning Light
Light glows (Fig. 17) if engine oil pressure drops below a
safe level while engine is running. If light flickers or
remains ON, stop vehicle, turn off engine and check oil
level. If oil level was low, but adding oil does not cause
light to go out when engine is restarted, turn engine off
immediately and contact your local TORO distributor for
assistance.
To check operation of warning lights:
1. Apply parking brake.
2. Turn ignition key to "ON", but do not start engine. The
oil pressure light should glow. If light does not function,
either a bulb is burned out or there is a malfunction in
the system which must be repaired.
Note: If engine was just turned off, it may take 1 to 2
minutes for light to come on.
Ignition Switch
The ignition switch (Fig. 17), used to start and stop the
engine, has three positions: OFF, RUN and START. Rotate
key clockwise — START position — to engage starter
motor. Release key when engine starts. The key will move
automatically to the ON position. To shut engine off, rotate
key counterclockwise to OFF position.
Hour Meter
Indicates the total hours of machine operation. The hour
meter (Fig. 18) starts to function whenever the key switch
is rotated to "ON" position.
Light Switch
Toggle switch (Fig. 18) to activate headlights. Push to turn
lights "ON".
Fuel Gauge
Shows amount of fuel in tank. Operates only when ignition
switch is in "ON" position (Fig. 18).
3rd High Lockout Switch
Moving switch (Fig. 18) to slow–
removing key will prevent use of third gear when in the
High range. Engine will shut off if shift lever is moved to
third gear when in High range. Key is installed with teeth
pointing downward. Push key in to turn. Key is removable
in either position.
1. Light switch
2. Hour meter
3. Fuel gauge
Steering Wheel
Turns vehicle. If engine stalls or power assist fails due to a
malfunction, vehicle steering will require greater effort
(Fig. 18).
Passenger Hand Hold
On dashboard (Fig. 19).
1. Passenger hand hold
Tachometer–Optional
– position and
Indicates engine RPM. Gear selection graphics indicates
speed (Fig. 19).
Remote Hydraulic Lever–Optional
Controls hydraulic flow to optional quick rear coupler.
24
3
2
4
Figure 18
2
1
Figure 19
5
1
4. 3rd high lockout switch
5. Steering wheel
2. Tachometer (optional)