Raising The Box In An Emergency - Toro Workman HD 07369 Operator's Manual

1. Hydraulic filter
3. Lubricate the gasket on the new filter.
4. Ensure that the filter mounting area is clean. Screw
the filter on until the gasket contacts the mounting
plate. Then tighten the filter one-half turn.
5. Start the engine and let it run for about two minutes
to purge air from the system. Stop the engine and
check the hydraulic oil level and for leaks.
Raising the Box in an
Emergency
The box can be raised in an emergency without starting
the engine by cranking starter or by jumping hydraulic
system.
Raising the Box using the Starter
Crank the starter while holding the lift lever in the Raise
position. Run the starter for 15 seconds then wait 60
seconds before engaging the starter again. If the engine
will not crank, you must remove the load and box
(attachment) to service the engine or transaxle.
Raising the Box by Jumping the
Hydraulic System
Before servicing or making adjustments to
the machine, stop the engine, set the parking
brake, and remove the key from the switch.
Any load material must be removed from the
bed or other attachment before working under
a raised bed. Never work under a raised bed
without positioning the safety support on the
fully extended cylinder rod.
Note: Two hydraulic hoses, each with a male and
female quick coupler, that fit the vehicle couplers are
required to perform this operation.
Figure 61
1. Back another vehicle up to the rear of the disabled
vehicle.
Important: The vehicles hydraulic system uses
Dexron III ATF. To avoid system contamination,
make sure the vehicle used to jump the hydraulic
system uses an equivalent fluid.
2. On both vehicles, disconnect the two quick coupler
hoses from the hoses secured to the coupler bracket
(Figure 62).
1. Quick coupler hose A
2. Quick coupler hose B
3. On the disabled vehicle, connect the two jumper
hoses to the hoses that were disconnected
(Figure 63). Cap the unused fittings.
1. Disconnected hoses
4. On the other vehicle, connect the two hoses to the
coupler still in the coupler bracket (connect the top
hose to the top coupler and the bottom hose to the
bottom coupler) (Figure 64). Cap the unused fittings.
48
Figure 62
Figure 63
2. Jumper hoses