Section 5 - Technical Data; Operational Limitations (English); Table 4 - Temperatures And Flows - Quantech QTC3040T Installation Operation & Maintenance

FORM QTC3-NM1
ISSUE DATE 08/03/2022

OPERATIONAL LIMITATIONS (ENGLISH)

TABLE 4 - TEMPERATURES AND FLOWS

TEMPERATURE
UNIT
DESIGNATION
MIN
QTC3070TSE 40
QTC3075TSE
40
QTC3085TSE 40
QTC3095TSE 40
QTC3110TSE 40
QTC3125TSE 40
QTC3140TSE 40
QTC3160TSE 40
QTC3040THE 40
QTC3050THE 40
QTC3055THE 40
QTC3060THE 40
QTC3080THE 40
QTC3090THE 40
QTC3100THE 40
QTC3120THE
40
QTC3130THE
40
QTC3150THE
40
QTC3170THE 40
QTC3205THE 40
QTC3225THE 40
NOTES:
1. For leaving liquid temperature below 40°F (4°C) (to 10°F [-12°C]) optional low temperature glycol kit required. Contact your
nearest Quantech Office for application requirements.
2. For leaving liquid temperature higher than 55°F (13°C), contact the nearest Quantech Office for application guidelines.
3. The evaporator is protected against freezing to -20°F (-29°C) with an electric heater as standard.
4. For operation at temperatures below 30°F (-1°C), install the optional Low Ambient Kit on the system.
5. For operation at temperatures below 0°F (-18°C), install the optional Low Ambient Kit with Variable Speed Fans on the system.
Excessive flow will cause damage to the
cooler. Do not exceed maximum cooler
flow. Special care should be taken when
multiple chillers are fed by a single pump.
QUANTECH
SECTION 5 – TECHNICAL DATA
WATER FLOW
(GPM) MIN
MAX
1 2
STANDARD EFFICIENCY
55
55
55
55
55
55
55
55
HIGH EFFICIENCY
55
55
55
55
55
55
55
55
55
55
55
55
55
WATER FLOW
(GPM) MAX
60 285
100 355
100 385
100 385
150 625
100 385
150 625
150 625
41 224
48 224
60 285
60 285
150 625
100 385
100 385
100 385
150 625
150 625
150 625
230 625
230 650
AIR ON CONDENSER (°F)
MIN MAX
3 4
-10 125
-10 125
-10 125
-10 125
-10 125
-10 125
-10 125
-10 125
-10 125
-10 125
-10 125
-10 125
-10 125
-10 125
-10 125
-10 125
-10 125
-10 125
-10 125
-10 125
-10 125
5 5
45