Remove The Solid-State Drive (Ssd) Stand Off - Lenovo V14 Gen 4 i Hardware Maintenance Manual

Go to
https://support.lenovo.com/partslookup
replacement parts:
Solid-state drive (SSD)
Solid-state drive (SSD) thermal pad

Remove the solid-state drive (SSD) stand off

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 38
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Remove one screw then remove the SSD by pulling it away from the slot.
Figure 14. Remove one screw then remove the SSD by pulling it away from the slot
Screw specifications
M2 x L2.8
Step 3. Remove the SSD stand off.
Figure 15. Remove the SSD stand off
Go to
https://support.lenovo.com/partslookup
replacement parts:
Solid-state drive (SSD)
to look up the Lenovo part numbers of the following
Number of screws
1
to look up the Lenovo part numbers of the following
.
Chapter 4 Removing a FRU or CRU
41