Remove the solid-state drive (SSD)
Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 28
Step 1.
Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2.
Remove one screw.
Figure 6. Remove one screw
Screw specifications
M2 x L3
Step 3.
Remove the SSD by pulling it away from the slot.
Figure 7. Remove the SSD
Go to
https://support.lenovo.com/partslookup
part:
SSD
Remove the Wi-Fi card
Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 28
30
Hardware Maintenance Manual
Number of screws
1
to look up the Lenovo part number of the following replacement