Remove The Solid-State Drive (Ssd) Module - Lenovo V14 Gen 4 i Hardware Maintenance Manual

Screw specifications
M2 x L5
Go to https://support.lenovo.com/partslookup
part:
Battery pack

Remove the solid-state drive (SSD) module

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 56
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Remove one screw.
Figure 48. Remove one screw
Screw specifications
M2 x L2.8
Step 3. Remove the SSD bracket.
Figure 49. Remove the SSD bracket
60
Hardware Maintenance Manual
Number of screws
6
to look up the Lenovo part number of the following replacement
Number of screws
1