Remove The 2242 Solid-State Drive (Ssd), Thermal Pad, And Holder - Lenovo IdeaPad Slim 5i Hardware Maintenance Manual

"Remove the lower case" on page 29
Note: Depending on the computer model, the battery pack might look different.
Step 1. Disconnect the battery pack cable from the system board, remove five screws, and remove the
battery pack.
Attention: Use your fingernail to pull the connector to unplug it. Do not pull the cable.
Figure 7. Remove the battery pack
Screw specifications
M2 × L3.5
M2 × L3.5
Go to https://support.lenovo.com/partslookup
replacement parts:
Battery pack

Remove the 2242 solid-state drive (SSD), thermal pad, and holder

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 29
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernail to pull the connector to unplug it. Do not pull the cable.
Step 2. Remove one screw and remove the 2242 SSD by pulling it away from the slot.
Number of screws
4 (for 57 Wh battery pack
models)
5 (for 76 Wh battery pack
models)
to look up the Lenovo part numbers of the following
Torque force (kgf.cm)
1.85 ± 0.15
1.85 ± 0.15
.
Chapter 4 Removing an FRU or CRU
31