Figure 96. Disconnect the EDP cable from the system board
Step 3.
Rotate the LCD unit to an angle of more than 90 degrees and place the computer on a flat surface
as shown. Remove four screws and then remove the LCD module.
Figure 97. Remove four screws and then remove the LCD module
Screw specifications
M2.5 x L5
Remove the upper case
Make sure the following FRUs (CRUs) have been removed.
"Remove the lower case" on page 77
"Remove the battery pack" on page 78
"Remove the solid-state drive (SSD) module" on page 78
"Remove the solid-state drive (SSD) stand off" on page 79
"Remove the Wi-Fi card" on page 80
"Remove the heat sink (for Lenovo V15 G4 AMN)" on page 81
Number of screws
4
.
Chapter 4
Removing a FRU or CRU
89