Disassemble The Lcd Module - Lenovo V14 Gen 4 i Hardware Maintenance Manual

"Remove the battery pack (for models without HDD)" on page 59
"Remove the solid-state drive (SSD) module" on page 60
"Remove the Wi-Fi card" on page 61
"Remove the CMOS battery" on page 62
"Remove the memory module" on page 63
"Remove the heat sink" on page 64
"Remove the fan" on page 65
"Remove the I/O board module" on page 66
"Remove the system board and the touchpad board cable" on page 67
"Remove the LCD module" on page 69
Go to https://support.lenovo.com/partslookup
part:
Upper case

Disassemble the LCD module

The LCD module as a whole is not an FRU. Instead, it contains FRUs as its components. Before
disassembling the LCD module, make sure it has been detached from the upper case.
Remove the LCD bezel
Make sure the following unit has been removed.
"Remove the LCD module" on page 69
Step 1. Remove the LCD bezel.
Figure 69. Remove the LCD bezel
Go to
https://support.lenovo.com/partslookup
part:
LCD bezel
Remove the hinges
Make sure the following FRUs (CRUs) have been removed.
"Remove the LCD module" on page 69
to look up the Lenovo part number of the following replacement
to look up the Lenovo part number of the following replacement
.
Chapter 4 Removing a FRU or CRU
71