Remove The Solid-State Drive (Ssd) Module - Lenovo ThinkBook 13s Gen 4 Hardware Maintenance Manual

Go to
https://support.lenovo.com/partslookup
part:
Battery pack

Remove the solid-state drive (SSD) module

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 28
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Peel off the SSD thermalpad.
Figure 6. Peel off the SSD thermalpad
Step 3. Remove one screw and then remove the SSD by pulling it away from the slot.
Figure 7. Remove the SSD by pulling it away from the slot
Screw specifications
M2 x L2
30
Hardware Maintenance Manual
to look up the Lenovo part number of the following replacement
Number of screws
1