Download Print this page

Specifications - Stihl MSA 220.0 T Instruction Manual

Hide thumbs Also See for MSA 220.0 T:

Advertisement

Available languages

Available languages

English
Condition
LEDs on
Battery
Chain saw cuts
1 LED glows
out during opera‐
red.
tion.
3 LEDs glow
red.
Run-time is too
short.
During sawing,
the wood
smokes or smells
burnt.
Battery is not
1 LED glows
being charged
red.
even though LED
on charger glows
green.
Chain Oil LED
glows red.
Chain Oil LED
flashes red.

26 Specifications

26.1
STIHL MSA 220.0 T, MSA
220.0 TC
– Approved battery types:
– STIHL AP 200, AP 300, AP 300 S,
AP 500 S
– STIHL AR series
42
Possible Cause
Remedy
Battery too hot /
► Remove the battery,
too cold.
► Engage the chain brake,
► Allow the chain saw and battery to cool down
gradually at ambient temperatures of about
Chain saw too
50 °F to 68 °F (10 °C to 20 °C).
hot.
Battery not fully
► Charge the battery,
charged.
Useful life of bat‐
► Have the battery checked by an authorized
tery has been
STIHL servicing dealer.
reached or
exceeded.
The chain is dull
► Properly sharpen the chain,
or improperly
sharpened.
Working techni‐
► Obtain instruction on proper working technique.
que is improper
or the saw is
being mis-used.
Insufficient bar
► Increase oil feed rate,
and chain oil.
► Have the chain lubrication mechanism checked
by an authorized STIHL servicing dealer.
Battery too hot /
► Allow the battery to warm up or cool down grad‐
too cold.
ually at ambient temperatures of about 50 °F to
68 °F (10 °C to 20 °C).
► Read and follow the warnings and instructions in
your charger's manual. For optimum perform‐
ance, observe the recommended ambient tem‐
perature ranges,
Insufficient bar
► Filling the Chain Oil Tank,
and chain oil in
► Adjust the oil pump to the maximum flow rate of
the tank, or the
bar and chain oil.
bar and chain
► Switching on the chain saw, fully press the trig‐
are not receiving
ger switch and run the chain saw for approxi‐
oil.
mate 1 minute.
Chain Oil LED goes out. The oil pump can be
set for operate the chain saw.
The bar and
► Filling and using new bar and chain lubricant,
chain lubricant is
dirty, old, too
► If the LEDs still glows, have the chain saw
dark to be detec‐
checked by an authorized STIHL servicing
ted by the oil
dealer.
sensor, or other‐
wise unsuitable.
The chain oil
► Have the chain oil sensor checked by an author‐
sensor is dam‐
ized STIHL servicing dealer.
aged.
When using a guide bar greater than 12"
(30 cm), use of a STIHL AR series battery or AP
battery bag with connecting cord is not author‐
ized.
– Weight without battery, guide bar and saw
– Maximum oil tank volume: 7.4 oz. (0.22 l)
26.6.
15.4.1.
chain: 5.95 lbs. (2.7 kg)
26 Specifications
17.2.
16.1.
11.
9.
15.4.3.
15.4.2.
0458-007-8201-B

Advertisement

loading

This manual is also suitable for:

Msa 220.0 tc