Table of Contents
Advertisement
The LCD screen will automatically turn off after the device is idle for a specified time. You can
press the power button at the device side panel or move your mouse to light up the screen.
Note
If you press the power button for more than 5 seconds, your device will be shut down.
3. Click Apply.
6.2 Network Configuration
6.2.1 TCP/IP
TCP/IP must be properly configured before you operate video recorder over network.
Steps
1. Go to Configuration → Network → General → TCP/IP .
2. Configure network parameters.
Working Mode
Multi-address Mode: The parameters of the two NIC cards can be configured
●
independently. You can select LAN1 or LAN2 in the NIC type field for parameter settings.
You can select one NIC card as default route. And then the system is connecting with the
extranet and the data will be forwarded through the default route.
Net-fault Tolerance Mode: The two NIC cards use the same IP address, and you can select
●
the Main NIC to LAN1 or LAN2. By this way, in case of one NIC card failure, the video
recorder will automatically enable the other standby NIC card so as to ensure the normal
running of the whole system.
Load Balance Mode: By using the same IP address and two NIC cards share the load of the
●
total bandwidth, which enables the system to provide two Gigabit network capacity
Note
Working mode is only available for certain models.
NIC Type
Select NIC type as your desire.
DHCP
If the DHCP server is available, you can check Enable DHCP to automatically obtain an IP
address and other network settings from that server.
MTU
The maximum transmission unit (MTU) is the size of the largest network layer protocol data
unit that can be communicated in a single network transaction.
Obtain DNS Automatically
Network Video Recorder User Manual
45
Advertisement
Table of Contents
