All Reset Mode - Kenwood ProTalk NX-P1200AV User Manual

At some point in time, you may desire to reset the transceiver settings to their
default values.
The following settings will return to the default values.
• Self-programming Mode
• Button Function Programming Mode
• VOX Function Setup Mode
With the transceiver power OFF, press and hold the PTT switch, the Side 1
1
button, and the Side 2 button while turning the transceiver power ON.
• Continue to hold the buttons, until the LED lights yellow.
Release the buttons within 2 seconds.
2
• Beep A (1 beep) sounds and returns to normal operation.
• If the buttons are released before the LED lights yellow or the buttons are
released after 2 seconds, All Reset Mode will cancel.
Note:
◆ Once the transceiver is programmed by your dealer, the dealer's settings are default
instead of the factory's settings at shipment.

ALL RESET MODE

48