Reserved Group Setup (Digital) - Kenwood ProTalk NX-P1200AV User Manual

Reserved Group Setup (Digital)

Reserved Group Setup allows you to congure the Reserved Group ID.
Reserved Group ID is the ID that is the destination of Group Call communication
in the channel where Selcall on PTT > Call Type (NXDN) is set to "Reserved
Group".
You can set the Reserved Group ID from "00001" to "65519". The default ID is
"00100".
• Only on the channels in Zone 4 of NX-P1300NU, Reserved Group function
(making a Group Call with the Reserved Group ID) can be used by default
settings.
• If you use Reserved Group function on NX-P1200NV or the other zones of NX-
P1300NU, the settings by your dealer are required.
• Reserved Group ID: 00100 is compatible with NX-P500.
• If other parties use the same frequency, changing the Reserved Group ID
and making a Group Call with a Group ID other than "00100" can prevent
unnecessary reception.
A group call is initiated to the transceiver of the same Reserved Group ID if the
PTT switch is pressed.
Transceiver A
Reserved Group
ID : 00100
To set the Reserved Group ID
With the transceiver power OFF, press and hold the Side 1 button and PTT
1
switch while turning the transceiver power ON.
• Continue to hold the Side 1 button and PTT switch until the LED lights
yellow and the transceiver announces "Self".
Release the Side 1 button and PTT switch to enter the ID SETUP/ ZONE
2
SELECTION.
Group Call receiving transceivers
Group Call
Transceiver D
Reserved Group
ID : 00100
20
Transceiver B
Reserved Group
ID : 00100
Transceiver C
Reserved Group
ID : 00100