Other Program Functions; Second Ptt; Cw Message; Fixed Volume - Kenwood ProTalk NX-P1200AV User Manual

The following program functions are set by your dealer.

SECOND PTT

By pressing this button, you can use the same operation as PTT switch to move to
a different channel (Second PTT Channel) from the standby channel and transmit.
• Second PTT Channel can be set for each zone.
• When starting transmission on the Second PTT Channel, the Second Channel
Tone will sound.
Note:
◆ Combined with Second Channel Scan, the transceiver scanning the standby channel
and Second PTT Channel at any time.
◆ To use the Second Channel Scan, the Scan Type must be set to "Second Channel".

CW MESSAGE

Allows you to send the congured CW Message.
Press this button to send congured CW Message (Morse code).

FIXED VOLUME

Allows you to change the volume level of the beep tone.
Press this button to change the volume level Low, High, or Off (tone Off).

RX/TX FREQUENCY SCAN

This function is for the repeater operation. The transceiver can receive uplink
signal directly even outside the repeater coverage area.
Press or hold this button to activate scan on the channel.
• The LED blinks blue and Beep A (1 beep) sounds.
In RX/TX Frequency Scan mode, press or hold this button to end scan.
• Beep B (2 beeps) sounds and the LED will stop blinking blue.

ZONE SELECT

Switches the Zone number instead of the Channel number by using the Selector.

OTHER PROGRAM FUNCTIONS

43