1. Manuals
  2. Brands
  3. Spectra Logic Manuals
  4. Storage
  5. Spectra nTier700
  6. Read this first

Spectra Logic Spectra nTier700 Read This First

Intelligent secondary storage appliance
Hide thumbs Also See for Spectra nTier700:
1
2

Advertisement

Table of Contents

See also: Instruction Manual , User Manual
Spectra
Thank you for purchasing the Spectra
Spectra Logic.

Setting the IP Address

As part of the initial installation, make sure you connect Ethernet port 1 on the back of the
nTier700 to an Ethernet network that can be accessed from a remote host. After you power-on the
nTier700, the next step is to set the IP address for Ethernet port 1 on the nTier700 rear panel. The
IP address for Ethernet port 1 displays on the operator panel of each nTier700 blade and is used to
access the nTier700 BlueScale
By default, Ethernet port 1 uses DHCP to obtain an IP address. To view the IP address assigned to
Ethernet port 1 or to set a static IP address, use the left arrow button (<) on the operator panel of
any blade to move to the IP Configuration tab (a globe icon) at the bottom of the screen.
If your site uses DHCP, the IP address displays on the screen.
If your site does not use DHCP, the IP address will be 0.0.0.0. Use the buttons on the
operator panel to assign a static IP address. Read "Setting the nTier700 IP Address" in the
Spectra nTier700 Intelligent Secondary Storage Appliance User Guide for instructions and
information.
®
nTier700
Storage Appliance
READ THIS FIRST
®
System Information
®
web interface to perform the initial configuration steps.
PN 90990031, Revision
™
Intelligent Secondary
™
nTier700
Intelligent Secondary Storage appliance from
Ethernet port 1
B

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Spectra nTier700 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Spectra Logic Spectra nTier700

Summary of Contents for Spectra Logic Spectra nTier700

  • Page 1: Read This First

    If your site does not use DHCP, the IP address will be 0.0.0.0. Use the buttons on the operator panel to assign a static IP address. Read “Setting the nTier700 IP Address” in the Spectra nTier700 Intelligent Secondary Storage Appliance User Guide for instructions and information.
  • Page 2 For security, the nTier700 blades are locked, even when the power is turned off. The first time you install the drives in a blade, you must unlock the blades without powering on the unit. See “Unlock the Blades” in the Spectra nTier700 Intelligent Secondary Storage Appliance User Guide for instructions.

Table of Contents