LIMITED TO THE IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, BOTH OF WHICH ARE EXPRESSLY DISCLAIMED. In no event shall Spectra Logic be liable for any loss of profits, loss of business, loss of use or data, interruption of business, or for indirect, special, incidental or consequential damages of any kind, even if Spectra Logic has been advised of the possibility of such damages arising from any defect or error.
Contacting Spectra Logic To obtain general information Spectra Logic Web Site: www.spectralogic.com United States Headquarters Spectra Logic Corporation 1700 North 55th Street Boulder, CO 80301 Phone: (800) 833-1132 or (303) 449-6400 International: 00 (1) 303 449 6400 Fax: (303) 939-8844...
Rack-Mounting the nTier700 These instructions describe rack-mounting a Spectra procedure is the same for both the nTier700 Intelligent Secondary Storage appliance and the nTier700 Deduplication Virtual Tape nTier700 (VTL) appliance. Both appliances are referred to as the nTier700 in these instructions.
The use of two-post “telco” racks is not supported. Note: An enclosed 19-inch, four-post rack is available for purchase from Spectra Logic. The rack has two doors and removable side panels to provide access to the sides of the nTier700.
Assemble the rack, if necessary. Identify the location in the rack where you will install the nTier700. For stability, Spectra Logic recommends mounting the nTier700 at the bottom of the rack. Figure 1 Ensure clearance between the rack’s front door and the front posts.
Rack-Mounting the nTier700 Rackmount the nTier700 Do not install the drives into the blades until after the nTier700 is installed in the rack. Install the Rack Shelf in the Rack 1. Position the shelf with the adjustable sliders toward the back of the rack. With one person lifting the front of the shelf and the other lifting the rear, angle the shelf into the rack so that the mounting tabs on the front and back of the shelf are positioned inside the rack posts.
Page 9
Figure 3 Install screws to secure the nTier700 to the rack. 4. You are now ready to install the drives in your nTier700. Refer to the Spectra nTier700 User Guide or Spectra nTier700 VTL Installation Guide for instructions. Rackmount the nTier700...