Advertisement
Quick Links
Advertisement
Related Manuals for Spectra Logic Spectra 2000
Summary of Contents for Spectra Logic Spectra 2000
- Page 1 Spectra 2000 Mammoth-2 Drive ™ Sled Assembly Guide P.N. 90870070 Revision B...
- Page 2 Information furnished in this manual is believed to be accurate and reliable. However, no responsibility is assumed by Spectra Logic for its use. Due to continuing research and development, Spectra Logic may revise this publication from time to time without notice, and reserves the right to change any product specification at any time without notice.
- Page 3 Contents Introduction ... 4 Assemble the Drive Sled... 5 Finish...8 Spectra 2000 Mammoth-2 Drive Sled Assembly Guide...
-
Page 4: About This Manual
About this manual This guide explains how to assemble a Mammoth-2 drive sled for use with a Spectra 2000 automated tape library. Caution: The Mammoth-2 tape drive is a static sensitive device. Use a static dissipative wrist strap or other ESD equipment/tools for this process. - Page 5 Figure 2 Align the Mammoth-2 in the Drive Sled. 3. The drive sled has two screw holes at the top of each side. Position the drive so its screw holes are aligned with the drive sled’s screw holes. Spectra 2000 Mammoth-2 Drive Sled Assembly Guide...
- Page 6 Figure 3 Attach the Mammoth-2 to the drive sled. Note: Make sure to use only the two screw holes at the top of each side of the drive sled. There should only be two screws on each side. Spectra 2000 Mammoth-2 Drive Sled Assembly Guide...
- Page 7 5. Turn the drive sled assembly over and plug the SCSI ID cable into the rear of the Mammoth-2 drive . The keyed connector will only plug into the drive with the tab facing up (Figure 4). Figure 4 Plug the SCSI ID cable into the drive. Spectra 2000 Mammoth-2 Drive Sled Assembly Guide...
- Page 8 There is a chance your Mammoth-2 drive sled may have been bent in shipping. Before installing the Mammoth-2 drive sled in your Spectra 2000 automated tape library, check to ensure the drive sled lip is flush with the drive face plate (Figure 5, Figure 6).
- Page 9 Remove the drive from the drive sled and try again. If you have difficulty If you need further assistance with this procedure, call Spectra Logic Technical Support at (800) 227-4637 or (303) 449-6444, extension 3175. Finish...