Pepperl+Fuchs VOC M-F256-B12-V1D-CR0 Series Manual page 19

Industrial Event Camera
Installation
Assigning a Fixed IP Address
When delivered, the sensor has a fixed IP address 192.168.100.50 and subnet mask
255.255.255.0. To enable communication within the network, the network settings of your
PC/laptop must be synchronized with the camera and may need to be adjusted. To do so, pro-
ceed as follows:
Setting the Fixed IP Address
The following section describes how to check the network connection settings of your Windows
PC and adapt them accordingly. The images in this description were created using
Windows 10. The description below also applies to later versions of Windows.
1.
Click the Windows "Start" button.
2.
Select "Control Panel > Network and Sharing Center."
3.
In the left window range, click "Change adapter settings."
4.
Select the required connection and right-click on your selection. In the selection window, select
"Properties."
5.
Double-click "Internet Protocol Version 4 (TCP/IPv4)."
19