Table of Contents
Advertisement
Industrial Event Camera
Product Specifications
2.6
Camera Optics
The VOC10M* camera has a horizontal angle of view of 62.2° and a vertical angle of view of
48.8°. In comparison, the VOC5M* camera has an even wider angle of view. It offers a horizon-
tal angle of view of 108.4° and a vertical angle of view of 92.2°.
Note
All cameras from production date 01/2023 are equipped with a motorized focus. The motorized
focus can be set via the user interface.
All cameras before production date 01/2023 have a fixed focus. The object distance is 1 m at
optimum depth of focus.
The integrated CMOS sensor has a resolution of 8 MP and a sensor surface of 3.68 mm x 2.76
mm.
An IR-cut filter is installed to prevent image quality from being affected by IR radiation.
2.7
The Heater
The integrated heater reduces condensation around the camera lens, especially in cold envi-
ronments. The heater can be activated as required.
The temperature in the area around the heater is controlled by a two-point controller. Depend-
ing on the status of the controller, the heating power has a nominal value of P = 0 W ("off") or
depending on the supply voltage V
Note
To avoid impermissibly high temperatures in the event of a control system failing due to
software, a software-independent excess temperature shut-off function for the heater unit is
integrated into the camera (shut-off value: 103 °C ± 2.5 °C).
The shut-off value refers to the position of the excess temperature sensor in the area around
the heater; other areas may be even warmer.
2.8
MicroSD card
An 8 GB industrial microSD card (Class 10 U1) is integrated into the camera for storing video
recordings.
Note
The microSD card must only be removed or replaced for service purposes. If servicing is
required, the two housing cover screws on the top (opposite the connector plugs) must be
removed. The two black plastic screw covers must be removed first.
2.9
Digital Input Trigger Signal
Triggering the digital input (DIGIN) initiates the recording of a video file.
•
This requires a rising edge at the DIGIN input in the high-level range, starting from the
specified low level range, and a corresponding minimum pulse length of 20 ms. A low sig-
nal must be present for 20 ms for a trigger signal to occur again. The software prevents
the acceptance of a new trigger signal for two seconds after a trigger signal is accepted.
•
Trigger signals with a pulse length of < 1.5 ms are not accepted. Pulses with a length
between 1.5 ms and 20 ms may result in a trigger signal.
2
, P = V
/50 ("on", 18 V --> 6.5 W, 24 V --> 11.5 W).
CC
CC
15
Advertisement
Table of Contents
