LET OP!
You should wait at least 3 minutes after aborting the start-up cycle before
restarting the fireplace.
If the stove interrupts the start-up cycle for technical reasons or if the stove
goes out after completing the start-up cycle, this may have several causes.
Check Annex 1 for possible solutions.
Switching off the fireplace
From run mode (the stove is on): press button 1 x (do not hold) to switch off
the stove. The KalSense ring lights up briefly.
Comfort + function
Moves to the last used comfort plus setting. Using the remote control, the
Comfort+ function can be activated and deactivated. After activating the
Comfort+ function, the KalSense lights up briefly and then goes out again.
KalSense feedback: green
From Comfort+ function, the following functions (buttons) cannot be activated:
Increase flame height (5)
Reduce flame height (6)
Comfort function (7)
The KalSense ring will light up red briefly each time you try to operate one of
the functions.
Thermostat function
Moves to the last thermostat setting selected. Using the remote control, the
thermostat function can be activated and deactivated. After activating the
thermostat function, the KalSense lights up briefly and then goes out again.
24