Kalfire Gi105/59F User Instructions page 23

CAUTION!
Change in the flame pattern after selecting a certain function almost
always occurs with some delay. Depending on the function selected, this
delay may be longer or shorter. The fireplace needs some time to
measure the temperature (in some cases), calculate the correct set
points and control the three gas valves.
Fireplace on
Press and hold the "fireplace on/off" button until the KalSense ring "fills up",
then immediately release the button. The stove goes through the start-up cycle.
During the start-up cycle, the KalSense ring flashes orange.
The start-up cycle is complete when the KalSense ring lights up white briefly
and then goes out.
CAUTION!
The entire start-up cycle takes several minutes (the fire goes through a safety
protocol, among other things, during the start-up cycle).
Switching on the fire / start-up cycle
If the on/off button has been held too long or too short, the KalSense ring
lights up briefly in red.
Restart the fireplace.
CAUTION!
During the start-up cycle, you cannot operate the various functions of the
fireplace. However, you can abort the start-up cycle using the on/off button.
23